HomeRad Power Bikes › Error 07

Rad Power Bikes error 07: Over voltage protection

Rad Power Bikes with Bafang hub motor and Rad LCD display (RadRover, RadCity, RadWagon, RadRunner, RadMini)WarningRide with caution

Battery voltage is above the controller's limit. Rad riders see this most often right after a full charge on a cold pack or with a non-original charger. Assist stays off until the voltage drops.

Likely causes

How to fix Rad Power Bikes error 07

  1. Unplug the charger; ride a few minutes on assist level 1 and power cycle
  2. Measure the battery: a 48V Rad pack should be at or below 54.6V
  3. Use only the Rad charger or one with the same output voltage
  4. If the voltage is fine and the code stays, contact Rad support about the controller
Go to a dealer if: Go to Rad support or a shop if the voltage checks out on a multimeter.
Warranty: Rad Power Bikes gives a 1-year limited warranty on electrical parts (2 years on some newer models and regions); contact Rad support with a video of the error before buying parts.
Typical cost: Original charger about USD 60-90; controller about USD 100-150.
Still stuck? Take a photo of the display and show it to a local e-bike workshop. Bring the bike's system name (e.g. Bosch Performance Line CX) and the exact code; that saves diagnostic time and money.

Frequently asked

Can I reset Rad error 07?

It clears when the voltage falls; ride gently and power cycle.

Can I keep riding?

Once cleared yes, but check the charger.

Warranty?

Controller faults are covered; using a wrong charger or battery is not.

Related Rad Power Bikes codes

22 · BMS communication error

Not an official Rad Power Bikes document. Compiled from workshop experience and public service information; details can differ per system version and bike brand.