HomeRad Power Bikes › Error 30

Rad Power Bikes error 30: Communication error

Rad Power Bikes with Bafang hub motor and Rad LCD display (RadRover, RadCity, RadWagon, RadRunner, RadMini)Fix at homeRide with caution

The display and controller are not communicating. The Rad display powers on but shows 30, freezes, or shows no data, and there is no assist. Almost always the display connector at the handlebar or a damaged harness wire.

Likely causes

How to fix Rad Power Bikes error 30

  1. Switch off, unplug the display connector, check for water and bent pins, clean, dry and re-seat with the collar locked
  2. Wiggle the harness with the bike on to find intermittent breaks
  3. Check the connectors at the controller end if you can reach them
  4. Contact Rad support; they will usually send a display or harness
Go to a dealer if: Go to a shop or Rad support if the connectors are clean and the code persists.
Warranty: Rad Power Bikes gives a 1-year limited warranty on electrical parts (2 years on some newer models and regions); contact Rad support with a video of the error before buying parts.
Typical cost: Harness about USD 30-50; display USD 80-130; controller USD 100-150.
Still stuck? Take a photo of the display and show it to a local e-bike workshop. Bring the bike's system name (e.g. Bosch Performance Line CX) and the exact code; that saves diagnostic time and money.

Frequently asked

How do I reset Rad error 30?

Re-seat the display connector and power cycle.

Can I keep riding?

Pedal home yes; assist is blocked.

Warranty?

Yes for display or controller failures.

Related Rad Power Bikes codes

21 · Speed sensor error04 · Throttle not in home position

Not an official Rad Power Bikes document. Compiled from workshop experience and public service information; details can differ per system version and bike brand.