HomeBosch › Error 460

Bosch error 460: USB error

Bosch BES2 (Purion, Intuvia, Kiox, Nyon)Fix at homeSafe to keep riding

The USB port on the display (Nyon, or Intuvia's charging port) has detected a problem: a device drawing too much current, a short in the cable, or water in the port. The bike keeps working.

Likely causes

How to fix Bosch error 460

  1. Unplug anything from the USB port
  2. Restart the system
  3. Inspect the socket for moisture or dirt and let it dry
  4. Try a different, known-good cable and device
  5. If the code appears with nothing connected, the port itself is damaged and a dealer can replace the display
Go to a dealer if: A dealer is needed only when 460 appears with an empty, dry USB socket, which means the port electronics are damaged.
Warranty: Damage from water or third-party accessories is not covered; a spontaneous port failure within warranty is.
Typical cost: Free if it is the accessory; a replacement display is 150-400 EUR/USD.
Still stuck? Take a photo of the display and show it to a local e-bike workshop. Bring the bike's system name (e.g. Bosch Performance Line CX) and the exact code; that saves diagnostic time and money.

Frequently asked

Can I reset Bosch error 460 myself?

Yes. Unplug the USB device, dry the port and restart the system.

Can I keep riding with error 460?

Yes. The drive keeps working normally with this code; it is a warning rather than a safety stop. Get it looked at when convenient, especially if it keeps coming back.

Is error 460 covered by warranty?

Damage from water or third-party accessories is not covered; a spontaneous port failure within warranty is.

Related Bosch codes

430 · On-board computer internal battery empty490 · Internal fault in the on-board computer

Not an official Bosch document. Compiled from workshop experience and public service information; details can differ per system version and bike brand.